The
end of the screwthread must bend in the shape of a swingle.
Roundwood
A round wood shaped like a broomstick and the
width of a hand. Must be drilled out and put on the swingle of the screwthread.
(Keep the roundwood in place with bolds)
Ball bearing
The ball bearing must be attached around the beginning and the end
of the straight part of the screwthread (If the screwthread doesn't
fit you can use some roundwood to make it fit).
Bold
On the top of the carveheadholder you must attach
a bold where the screwthread has to go through.
Ironsheet
The carveheadmover can be attached to the arm with ironsheet. The
ironsheet must be cut in strips and put around the ball bearings (the
size of the strips is depending on the size of the ball bearing). Make
holes in the arm to put the ball bearings in.